Centrifugal finishing machine model: LXQ30B
LXQ30B type: 1. equipment functions: 1. Remove burrs, burrs, oxide scale, rust, turning tool lines, coatings and slight scratches on the surface of the workpiece; 2. Blunt treatment of sharp corners, edges, sharp edges and tough mouths of the workpiece; 3. Polish the surface of the workpiece to reduce the surface roughness of the workpiece. 4. Eliminate the stress of the workpiece and improve the surface strength of the workpiece. 2. scope of application: suitable for length less than 260mm, width less than 150mm of various materials of the workpiece. The polishing effect of the centrifugal finishing machine is much higher than that of other models, and it is more suitable for polishing the workpiece. 3. equipment features: 1, with frequency conversion system, grinding barrel speed of 0-180 r/min minutes, can be adjusted according to the need. 2. The lining barrel is made of imported wear-resistant polyurethane and can be replaced at any time. It has the characteristics of acid and alkali resistance, low cost, long service life and fast replacement speed. 3, the use of high-strength nylon gear transmission, with low noise, long service life, stable operation balance and so on. 4. It adopts arc sliding door design and is equipped with safety contact switch, which has the characteristics of saving space and safe operation. 5. The model is equipped with horizontal grinding barrel and inclined grinding barrel, which can be purchased by customers according to their needs.
Key words:
Surface Treatment
Classification:
Centrifugal finishing machine series
Hotline:
Detailed introduction
LXQ30B Type:
1. device features:
1Remove burrs, burrs, oxide skin, rust, lathe pattern, coating and slight scratches on the surface of the workpiece;
2The sharp corners, edges, sharp edges and tough mouth of the workpiece shall be obtuse-treated;
3The surface of the workpiece is polished to reduce the surface roughness of the workpiece.
4Eliminate the stress of the workpiece and improve the surface strength of the workpiece.
2. scope of application:
Suitable for length less than 260mmWorkpieces of various materials with a width of less than 150mm.The polishing effect of the centrifugal finishing machine is much higher than that of other models, and it is more suitable for polishing the workpiece.
3. equipment features:
14. With frequency conversion system, the rotating speed of grinding barrel is 0-180Turn/minute, can be adjusted according to the need.
2The lining barrel is made of imported wear-resistant polyurethane and can be replaced at any time. It has the characteristics of acid and alkali resistance, low cost, long service life and fast replacement speed.
3Using high-strength nylon gear transmission, with low noise, long service life, stable operation balance and so on.
4It adopts arc sliding door design and is equipped with safety contact switch, which has the characteristics of saving space and safe operation.
5This model is equipped with horizontal grinding barrel and inclined grinding barrel, which can be purchased by customers according to their needs.
4. main parameter table:
online message